Omni Rally Magazine Extension Aluminum - 140mm (Beretta | Walther | CANIK | SIG)

Omni Rally Magazine Extension Aluminum - 140mm (Beretta | Walther | CANIK | SIG)

RESTRICTED ITEM: Due to capacity restrictions, we are unable to ship this product to the following locations: ANY country outside the US, California, Colorado, Connecticut, Delaware, Hawaii, Illinois, Maryland, Massachusetts, New Jersey, New York, Rhode Island, Vermont, Washington

*Due to variation in magazine tubes, fitting may be required

Weight
~1.03oz

CNC machined from solid 6061 Aluminum and anodized several colors.

Our Rally bases are designed with extra grooves on the sides for added grip during reloads.

Our spring-loaded pin makes installation and removal a breeze! There are no tools required, they come fully assembled so you don't need to worry about losing small screws or tools at the range or in the middle of a competition.
The quick removal/install makes magazine maintenance easy anywhere, anytime!

The indent on the front of the base helps provide a secure consistent grip on your magazine without looking so you can keep your focus on the target! 

WORKS WITH:

Beretta Mec-Gar 18rd 9mm magazine(and 15rd dimpled magazines)
- *Fits USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower(Does NOT expand capacity of 15rd dimpled mags)

Walther PDP 18rd 9mm magazine
- *Fits USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower

Canik Rival & TP9 18rd 9mm magazine
- *Fits USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower

Sig Sauer P226 15rd 9mm magazine
- Does NOT fit USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower

Magwell compatibility:
Our bases are always designed to work with LOK Grips magwells
Other Manufacturers: By design, these should work with most magwells, but we can only guarantee fitment with our magwells. Contact us if you have any issues at all.

*Disclaimer: As with any competition-focused modifications, always ensure you thoroughly test your gear before using it in a competition setting. Specifically for 140mm/170mm magazine setups, be sure to verify that your magazine fits within the USPSA 140mm/170mm gauge. Due to the nature of mass-produced items like magazines, slight variations can occur, particularly in the magazine lips that connect with the extension or base pad.
*Capacity: Capacity may vary due to variations in mag tubes, followers, and springs. If you are unable to fit an additional 4 rounds, first try reinstalling the base, loading and unloading the mag, load the mag and rack a few rounds through then reloading the mag. Sometimes, the spring just needs to be worked into place with the new base.

Installation
- No tools required for installation!
- Simply remove your current base and locking plate, then slide our base pad on from the rear
If you are unsure how to properly install this product, we recommend having a knowledgeable gunsmith perform the installation. We are not responsible for any damage caused by improper installation. 

**Returns/Exchanges: We cannot take it back if it has been scratched or damaged in any way. You may return/exchange within 60 days of delivery undamaged and in new condition.

Warranty:
Repeatedly dropping on hard surfaces will eventually result in damage or failure - this is NOT covered by warranty. If you experience any failures, please contact us right away.