Omni Rally Magazine Extension Aluminum - 140mm (Beretta | Walther | CANIK | SIG)

Omni Rally Magazine Extension Aluminum - 140mm (Beretta | Walther | CANIK | SIG)

RESTRICTED ITEM: Due to capacity restrictions, we are unable to ship this product to the following locations: ANY country outside the US, California, Colorado, Connecticut, Delaware, Hawaii, Illinois, Maryland, Massachusetts, New Jersey, New York, Rhode Island, Vermont, Washington

*Due to variation in magazine tubes, fitting may be required

Weight
~1.03oz

CNC machined from solid 6061 Aluminum and anodized several colors.

Our Rally bases are designed with extra grooves on the sides for added grip during reloads.

Our spring-loaded pin makes installation and removal a breeze! There are no tools required, they come fully assembled so you don't need to worry about losing small screws or tools at the range or in the middle of a competition.
The quick removal/install makes magazine maintenance easy anywhere, anytime!

The indent on the front of the base helps provide a secure consistent grip on your magazine without looking so you can keep your focus on the target! 

WORKS WITH:

Designed for use with a magwell: These bases leave clearance for a magwell. Without a magwell installed, a visible gap will remain between the base and frame.

Beretta Mec-Gar 18rd 9mm magazine(and 15rd dimpled magazines)
- *Fits USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower(Does NOT expand capacity of 15rd dimpled mags)

Walther PDP 18rd 9mm magazine
- *Fits USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower
Walther Pro Series Compatibility
We cannot guarantee compatibility with any of the Walther Pro Series accessories. It is best to install LOK Grips Backstrap, Magwell, and Mag Bases

Canik Rival & TP9 18rd 9mm magazine
- *Fits USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower

Sig Sauer P226 15/18rd 9mm magazine
- *Fits USPSA 140mm magazine gauge
- Works with factory spring and follower
- *Capacity: +4 rounds with factory spring/follower

Magwell compatibility:
Our bases are always designed to work with LOK Grips magwells
Other Manufacturers: By design, these should work with most magwells, but we can only guarantee fitment with our magwells. Contact us if you have any issues at all.

*Disclaimer: As with any competition-focused modifications, always ensure you thoroughly test your gear before using it in a competition setting. Specifically for 140mm/170mm magazine setups, be sure to verify that your magazine fits within the USPSA 140mm/170mm gauge. Due to the nature of mass-produced items like magazines, slight variations can occur, particularly in the magazine lips that connect with the extension or base pad.
*Capacity: Capacity may vary due to variations in mag tubes, followers, and springs. If you are unable to fit an additional 4 rounds, first try reinstalling the base, loading and unloading the mag, load the mag and rack a few rounds through then reloading the mag. Sometimes, the spring just needs to be worked into place with the new base.

Installation
- No tools required for installation!
- Simply remove your current base and locking plate, then slide our base pad on from the rear
If you are unsure how to properly install this product, we recommend having a knowledgeable gunsmith perform the installation. We are not responsible for any damage caused by improper installation. 

**Returns/Exchanges: We cannot take it back if it has been scratched or damaged in any way. You may return/exchange within 60 days of delivery undamaged and in new condition.

Warranty:
Repeatedly dropping on hard surfaces will eventually result in damage or failure - this is NOT covered by warranty. If you experience any failures, please contact us right away.